Skip to content

G4 Chin Mount Installation

    1. INSTALL BUNGEE

    Loop the bungee through the grill twice as shown above. You may have to peel the bottom of the rubber on the inside of the vent slightly for access. Try not to peel the whole piece off as it is tricky to get back. A pair of tweezers may come in handy as there is a piece of plastic behind the grill.

    2. TIE KNOT IN BUNGEE

    Tie the ends of the bungee reasonably tightly as this hold the mount tight to the grill. Add an extra knot to make sure it doesn’t become undone

    Again we recommend you take care not to peel the whole rubber piece out. Its really hard to get back in and may result in your breath showing on cold days

    Cut the excess bungee leaving around 1cm and tuck it under the rubber. Press the rubber back into position

    3. INSERT TAB INTO BUNGEE

    Pull the bungee just enough to insert the tab of the mount below the bungee

    4. HOOK OVER LIP OF HELMET

    Pull/rotate the mount slightly away from the helmet so you can hook the bottom of the mount over the bottom of the chin of the helmet. When you release the tension the small knobs will align with holes in the vent

    5 INSERT CAMERA

    Place the camera into the mount at an angle then ensure it is fully seated.

    If you have any issues during installation please send us a message using the messenger button on this website or emailing us at info@skydive.parts